Search results
Results from the WOW.Com Content Network
Double-precision binary floating-point is a commonly used format on PCs, due to its wider range over single-precision floating point, in spite of its performance and bandwidth cost. It is commonly known simply as double. The IEEE 754 standard specifies a binary64 as having: Sign bit: 1 bit; Exponent: 11 bits
A minifloat in 1 byte (8 bit) with 1 sign bit, 4 exponent bits and 3 significand bits (in short, a 1.4.3 minifloat) is demonstrated here. The exponent bias is defined as 7 to center the values around 1 to match other IEEE 754 floats [ 3 ] [ 4 ] so (for most values) the actual multiplier for exponent x is 2 x −7 .
It was designed to support a 32-bit "single precision" format and a 64-bit "double-precision" format for encoding and interchanging floating-point numbers. The extended format was designed not to store data at higher precision, but rather to allow for the computation of temporary double results more reliably and accurately by minimising ...
On a typical computer system, a double-precision (64-bit) binary floating-point number has a coefficient of 53 bits (including 1 implied bit), an exponent of 11 bits, and 1 sign bit. Since 2 10 = 1024, the complete range of the positive normal floating-point numbers in this format is from 2 −1022 ≈ 2 × 10 −308 to approximately 2 1024 ≈ ...
Huberto M. Sierra noted in his 1956 patent "Floating Decimal Point Arithmetic Control Means for Calculator": [1] Thus under some conditions, the major portion of the significant data digits may lie beyond the capacity of the registers.
Double-precision floating-point format; Quadruple-precision floating-point format; Octuple-precision floating-point format; Of these, octuple-precision format is rarely used. The single- and double-precision formats are most widely used and supported on nearly all platforms. The use of half-precision format and minifloat formats has been ...
This standard defines the format for 32-bit numbers called single precision, as well as 64-bit numbers called double precision and longer numbers called extended precision (used for intermediate results). Floating-point representations can support a much wider range of values than fixed-point, with the ability to represent very small numbers ...
As an 8-bit exponent was not wide enough for some operations desired for double-precision numbers, e.g. to store the product of two 32-bit numbers, [20] both Kahan's proposal and a counter-proposal by DEC therefore used 11 bits, like the time-tested 60-bit floating-point format of the CDC 6600 from 1965.