Ads
related to: measuring bolt length chartboltdepot.com has been visited by 10K+ users in the past month
walmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The length of a machine screw or bolt is indicated by an × and the length expressed in millimetres (e.g. M8-1.25×30 or M8×30). [citation needed] Tolerance classes defined in ISO 965-1 can be appended to these designations, if required (e.g. M500– 6g in external threads). External threads are designated by lowercase letter, g or h.
Confusion can arise because each Whitworth hexagon was originally one size larger than that of the corresponding BSF fastener. This leads to instances where for example, a spanner marked 7 ⁄ 16 BSF is the same size as one marked 3 ⁄ 8 W. In both cases the spanner jaw width of 0.710 in, the width across the hexagon flat, is the same.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
Calipers measure the female minor diameter (inside diameter, ID), which is less than caliper measurement of the male major diameter (outside diameter, OD). For example, tables of caliper measurements show 0.69 female ID and 0.75 male OD for the standards of "3/4 SAE J512" threads and "3/4-14 UNF JIS SAE-J514 ISO 8434-2". [ 6 ]
The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts
For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including: Internal hex drive: ISO 2936:2014 "Assembly tools for screws and nuts—Hexagon socket screw keys" [5] External hex drive: ISO 4014, 4016, 4017, and 4018 [6]
Ads
related to: measuring bolt length chartboltdepot.com has been visited by 10K+ users in the past month
walmart.com has been visited by 1M+ users in the past month