Search results
Results from the WOW.Com Content Network
In thermodynamics, the enthalpy of sublimation, or heat of sublimation, is the heat required to sublimate (change from solid to gas) one mole of a substance at a given combination of temperature and pressure, usually standard temperature and pressure (STP). It is equal to the cohesive energy of the solid.
Solid carbon dioxide sublimes rapidly along the solid-gas boundary (sublimation point) below the triple point (e.g., at the temperature of −78.5 °C, at atmospheric pressure), whereas its melting into liquid CO 2 can occur along the solid-liquid boundary (melting point) at pressures and temperatures above the triple point (i.e., 5.1 atm, − ...
A sublimatory [1] [2] or sublimation apparatus is equipment, commonly laboratory glassware, for purification of compounds by selective sublimation. In principle, the operation resembles purification by distillation , except that the products do not pass through a liquid phase .
The large ice crystals form a network within the product which promotes faster removal of water vapor during sublimation. [2] To produce larger crystals, the product should be frozen slowly or can be cycled up and down in temperature in a process called annealing. The freezing phase is the most critical in the whole freeze-drying process, as ...
Its construction and principle of operation is simple. It consists of a titanium filament through which a high current (typically around 40 A) is passed periodically. This current causes the filament to reach the sublimation temperature of titanium, and hence the surrounding chamber walls become coated with a thin film of clean titanium.
The density of dry ice increases with decreasing temperature and ranges between about 1.55 and 1.7 g/cm 3 (97 and 106 lb/cu ft) below 195 K (−78 °C; −109 °F). [3] The low temperature and direct sublimation to a gas makes dry ice an effective coolant, since it is colder than water ice and leaves no residue as it changes state. [4]
A typical phase diagram.The solid green line applies to most substances; the dashed green line gives the anomalous behavior of water. In thermodynamics, the triple point of a substance is the temperature and pressure at which the three phases (gas, liquid, and solid) of that substance coexist in thermodynamic equilibrium. [1]
The most common dyes used for sublimation activate at 350 degrees Fahrenheit / 175 degrees Celsius. However, a range of 380 to 420 degrees Fahrenheit / 195 to 215 degrees Celsius is normally recommended for optimal color. The result of the sublimation transfer process is a nearly permanent, high-resolution, full-color print.