Search results
Results from the WOW.Com Content Network
Firebox of a GWR 6959 Class steam locomotive, showing the underside of the brick arch, constructed from specially-shaped firebricks. Empty firebox of a Baureihe 52, showing the brick arch. There is a large brick arch (made from fire brick) attached to the front wall (boiler throat plate) of the firebox immediately beneath the firetubes. This ...
The inner firebox was D-shaped in plan, with a flat tubeplate. Fireboxes of this time did not yet have a brick arch and so the Bury firebox was relatively short in length but tall, to give an adequate length of combustion path. The outer firebox was a vertical cylinder, formed into a tall hemispherical dome above it. [3]
A locomotive boiler with a wide firebox may have arch tubes or thermic syphons. As firebox technology developed, it was found that placing a baffle of firebricks (heat-resistant bricks) inside the firebox to direct the flow of hot flue gasses up into the top of the firebox before it flowed into the fire tubes increased efficiency by equalizing ...
Firebox: • Grate area: Original: 35 sq ft (3.3 m 2) Rebuilt: 50 sq ft (4.6 m 2) Boiler: Original: Diagram 103 Rebuilt: Diagram 111: Boiler pressure: Original: 450 psi (3.10 MPa) Rebuilt: 250 psi (1.72 MPa) Cylinders: Original: Four (compound); two high pressure inside; two low pressure outside Rebuilt: Three (simple) Cylinder size
The hatched circles show the outline of the barrel to which the firebox was attached. A Round-topped firebox cross section shown for comparison. Note the angling of the stays. Pacific-type flat-topped inner firebox. The Belpaire firebox is a type of firebox used on steam locomotives. It was invented by Alfred Belpaire of Belgium in 1864. Today ...
4-6-0 camelback locomotive, complete with Wootten firebox. The Wootten firebox is a type of firebox used on steam locomotives. The firebox was very wide to allow combustion of anthracite waste, known as "culm". [1] Its size necessitated unusual placement of the crew, examples being camelback locomotives. The Wootten firebox made for a free ...
Interactive geometry software (IGS) or dynamic geometry environments (DGEs) are computer programs which allow one to create and then manipulate geometric constructions, primarily in plane geometry. In most IGS, one starts construction by putting a few points and using them to define new objects such as lines , circles or other points.
Class D16 on the Pennsylvania Railroad was their final development of the 4-4-0 "American" type of steam locomotive. [2] A total of 429 of these locomotives were built at the PRR's Juniata Shops, spread across five subclasses; some had 80 in (2,030 mm) diameter driving wheels for service in level territory, while others had 68 in (1,730 mm) drivers for mountainous terrain. [3]