Search results
Results from the WOW.Com Content Network
Non-SMD types of LED lighting also exist, such as COB (chip on board) and MCOB (multi-COB). Surface-mounted device LED modules are described by the dimensions of the LED package. A single multicolor module may have three individual LEDs within that package, one each of red, green and blue, to allow many colors or shades of white to be selected ...
An LED strip, tape, or ribbon light is a flexible circuit board populated by surface-mount light-emitting diodes (SMD LEDs) and other components that usually comes with an adhesive backing. Traditionally, strip lights had been used solely in accent lighting, backlighting, task lighting, and decorative lighting applications, such as cove lighting .
MICRO SMD-Chip-size package (CSP) developed by National Semiconductor [21] COB: Chip on board: Bare die supplied without a package. It is mounted directly to the PCB using bonding wires and covered with a blob of black Epoxy. [22] Also used for LEDs. In LEDs, transparent epoxy or a silicon caulk-like material that may contain a phosphor is ...
A 1979 SAA5050 in a VDU card for Acorn Eurocard systems. The Mullard SAA5050 was a character generator chip for implementing the Teletext character set. [1]Printed circuit board used in a Philips Viewdata unit, featuring a SAA5050 character generator.
The SMD interface is based upon a definition of two flat interface cables ("A" control and "B" data) which run from the disk drive to a hard disk drive interface and then to a computer. This interface allows data to be transferred at 9.6 Mbit/s. The SMD interface was supported by many 8 inch and 14 inch removable and non-removable disk drives.
Ceramic capacitors may experience changes to their electrical parameters due to soldering stress. The heat of the solder bath, especially for SMD styles, can cause changes of contact resistance between terminals and electrodes. For ferroelectric class 2 ceramic capacitors, the soldering temperature is above the Curie point. The polarized ...
The integrated circuit package must resist physical breakage, keep out moisture, and also provide effective heat dissipation from the chip. Moreover, for RF applications, the package is commonly required to shield electromagnetic interference, that may either degrade the circuit performance or adversely affect neighboring circuits.
These devices are widely used and recommended for general-purpose power-frequency rectifier use. [11] [12] They are commonly used as rectifiers in AC adapters of electrical appliances to convert AC to DC, [13] and are also used in other types of power converters, [2] or as freewheeling diodes to protect circuits from inductive loads.