Search results
Results from the WOW.Com Content Network
The middle leg is square throughout its length, while the outer legs are thinner at the top, flaring towards the bottom. Held together, the three legs thus form a dovetail shape. The lewis hole seating is undercut (similar to a chain-linked lewis hole) to match its profile. The first outer leg is inserted into the lewis hole, followed by the ...
The right outrigger stays in the centerline while the left outrigger moves outboard. This derrick will lower or heave cargo as both guys are veered or hauled. Three winches, controlled by joystick, are necessary to operate the Hallen derrick: two for the guys and one for the purchase. Limit switches are used to avoid an over-topping or over ...
Stirrup sample. Stirrups form the outer part of a rebar cage. The function of stirrups (often referred to as 'reinforcing steel links' and 'shear links') is threefold: to give the main reinforcement bars structure, to maintain a correct level of concrete cover, and to maintain an equal transferance of force throughout the supporting elements. [30]
[3] Formwork for beams takes the form of a box that is supported and propped in the correct position and level. The removal time for the formwork will vary with air temperature, humidity and consequent curing rate. Typical striking times are as follows (using air temperature of 7-16 °C): Form work. Beam sides: 9–12 hours. Beam soffits: 8 ...
ACI Code 7.10.4.2: For cast-in-place construction, size of spirals shall not be less than 3/8 in. diameter. ACI Code 7.10.4.3: Clear spacing between spirals shall not exceed 3 in., nor be less than 1in. Section 10.9.3 adds an additional lower limit to the amount of spiral reinforcement via the volumetric spiral reinforcement ratio ρ s.
A jib or jib arm is the horizontal or near-horizontal beam used in many types of crane to support the load clear of the main support. [1] [2] An archaic spelling is gib. [3] Usually jib arms are attached to a vertical mast or tower or sometimes to an inclined boom.
A flitch beam (or flitched beam) is a compound beam used in the construction of houses, decks, and other primarily wood-frame structures. Typically, the flitch beam is made up of a vertical steel plate sandwiched between two wood beams, the three layers being held together with bolts. In that common form it is sometimes referenced as a steel ...
A plain scarf joint A nibbed scarf joint A keyed, nibbed scarf, reinforced with fish plates and through bolts The scarf joint used on the beams above the post is known by its French name, trait de jupiter, or bolt-o-lightning joint. A scarf joint, or scarph joint, is a method of joining two members end to end in woodworking or metalworking. [1]