enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Bolted joint in vertical section Screw joint. The distinction between a bolt and a screw is poorly defined. The academic distinction, per Machinery's Handbook, [3] is in their intended purpose: bolts are designed to pass through an unthreaded hole in a component and be fastened with the aid of a nut. Screws in contrast are used in components ...

3. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   Differentiation between bolt and screw. The Machinery's Handbook describes the distinction between bolts and screws as follows: A bolt is an externally threaded fastener designed for insertion through holes in assembled parts, and is normally intended to be tightened or released by torquing a nut.

4. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Sex bolt: Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt Has a barrel-shaped flange and protruding boss that is internally threaded Split nut: Split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew Sleeve nut ...

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   sex bolt, Chicago screw: A fastener comprising a mated pair of screw and post (binding barrel), which are a machine screw and a nut that is barrel-shaped. The nut has a flange and a protruding boss that is internally threaded. The bolt (mated pair, screw and post) sits within the components being fastened, and the flange provides the bearing ...

6. Bolted joint - Wikipedia

   en.wikipedia.org/wiki/Bolted_joint

   The preload achieved by torquing a bolt is caused by the part of the torque that is effective. Friction in the threads and under the nut or bolt head uses up some fraction of the applied torque. Much of the torque applied is lost overcoming friction under the torqued bolt head or nut (50%) and in the threads (40%).

7. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   Another common inspection point is the straightness of a bolt or screw. This topic comes up often when there are assembly issues with predrilled holes as the first troubleshooting point is to determine if the fastener or the hole is at fault. ASME B18.2.9 "Straightness Gage and Gaging for Bolts and Screws" was developed to address this issue.