Search results
Results from the WOW.Com Content Network
Note the aileron deflection on the right wing. Diagram of how an aileron roll is performed in relation to other common rolls. The aileron roll is an aerobatic maneuver in which an aircraft does a full 360° revolution about its longitudinal axis. When executed properly, there is no appreciable change in altitude and the aircraft exits the ...
A raised aileron reduces lift on that wing and a lowered one increases lift, so moving the aileron control in this way causes the left wing to drop and the right wing to rise. This causes the aircraft to roll to the left and begin to turn to the left. Centering the control returns the ailerons to the neutral position, maintaining the bank angle ...
Spoiler controls can be used for roll control (outboard or mid-span spoilers) or descent control (inboard spoilers). Some aircraft use spoilers in combination with or in lieu of ailerons for roll control, primarily to reduce adverse yaw when rudder input is limited by higher speeds.
Yawing also increases the speed of the outboard wing whilst slowing down the inboard wing, with corresponding changes in drag causing a (small) opposing yaw moment. N r {\displaystyle N_{r}} opposes the inherent directional stiffness which tends to point the aircraft's nose back into the wind and always matches the sign of the yaw rate input.
The down moving aileron also adds energy to the boundary layer. The edge of the aileron directs air flow from the underside of the wing to the upper surface of the aileron, thus creating a lifting force added to the lift of the wing. This reduces the needed deflection of the aileron.
Adverse yaw is a secondary effect of the inclination of the lift vectors on the wing due to its rolling velocity and of the application of the ailerons. [2]: 327 Some pilot training manuals focus mainly on the additional drag caused by the downward-deflected aileron [3] [4] and make only brief [5] or indirect [6] mentions of roll effects.
In February 1976, work commenced to automate the methods contained in the USAF Stability and Control DATCOM, specifically those contained in sections 4, 5, 6 and 7.The work was performed by the McDonnell Douglas Corporation under contract with the United States Air Force in conjunction with engineers at the Air Force Flight Dynamics Laboratory in Wright-Patterson Air Force Base.
Ailerons are similar to flaps (and work the same way), but are intended to provide lateral control, rather than to change the lifting characteristics of both wings together, and so operate differentially – when an aileron on one wing increases the lift, the opposite aileron does not, and will often work to decrease lift.