enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fascia (architecture) - Wikipedia

   en.wikipedia.org/wiki/Fascia_(architecture)

   The horizontal "fascia board" which caps the end of rafters outside a building may be used to hold the rain gutter. The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the ...

3. Soffit - Wikipedia

   en.wikipedia.org/wiki/Soffit

   Its archetypal form, sometimes incorporating or implying the projection of rafters or trusses over the exterior of supporting walls, is the underside of eaves (to connect a supporting wall to projecting edge(s) of the roof). The vertical band at the edge of the roof is called a fascia. A soffit of an arch is frequently called an intrados.

4. Rain gutter - Wikipedia

   en.wikipedia.org/wiki/Rain_gutter

   The Victorian gutter was an ogee, 115 mm in width, that was fitted directly to the fascia boards eliminating the need for brackets. Square and half-round profiles were also available. For a brief period after the first world war , asbestos-cement guttering became popular due to it being maintenance free: the disadvantages however ensured this ...

5. Eaves - Wikipedia

   en.wikipedia.org/wiki/Eaves

   Eaves overhang, shown here with a bracket system of modillions. The eaves are the edges of the roof which overhang the face of a wall and, normally, project beyond the side of a building. The eaves form an overhang to throw water clear of the walls and may be highly decorated as part of an architectural style, such as the Chinese dougong ...

6. Bargeboard - Wikipedia

   en.wikipedia.org/wiki/Bargeboard

   Bargeboard, 1908 illustration. A bargeboard or rake fascia is a board fastened to each projecting gable of a roof to give it strength and protection, and to conceal the otherwise exposed end grain of the horizontal timbers or purlins of the roof.

7. Lookout (architecture) - Wikipedia

   en.wikipedia.org/wiki/Lookout_(architecture)

   A lookout, [1] lookout rafter or roof outlooker [2] is a wooden joist that extends in cantilever out from the exterior wall (or wall plate) of a building, supporting the roof sheathing and providing a nailing surface for the fascia boards. When not exposed it serves to fasten the finish materials of the eaves.

8. Plane crashes into parking lot near track during NHRA season ...

   www.aol.com/sports/plane-crashes-parking-lot...

   The In-N-Out Burger Pomona Dragstip is located just southeast of Brackett Field Airport. The airport is just north of Interstate 10 east of Los Angeles.

9. Rafter - Wikipedia

   en.wikipedia.org/wiki/Rafter

   Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.