Search results
Results from the WOW.Com Content Network
Sealed cartridge bottom brackets are normally two pieces, a unit holding the spindle and bearings that screws into the bottom bracket shell from the drive side and a screw-in support cup (often made of light alloy or plastic) that supports the spindle and bearing assembly on the non-drive side.
There is a bearing surface on the spindle, and on each of the cups that thread into the frame. The bottom bracket may be overhaulable (an adjustable bottom bracket) or not overhaulable (a cartridge bottom bracket). The bottom bracket fits inside the bottom bracket shell, which is part of the bicycle frame
The bottom bracket shell is a short and large diameter tube, relative to the other tubes in the frame, that runs side to side and holds the bottom bracket. It is usually threaded, often left-hand threaded on the right (drive) side of the bike to prevent loosening by fretting induced precession , and right-hand threaded on the left (non-drive) side.
A cartridge being pushed into the chamber of a Springfield M1903. The chamber of a firearm is the cavity at the back end of a breechloading weapon's barrel or cylinder, where the ammunition is inserted before being fired. The rear opening of the chamber is the breech, and is sealed by the breechblock or the bolt. [1] [2]
The semi-axles attached in the middle of a standard BSA bottom bracket shell with a Hirth type joint and internal bolt. In 2004 Lightning licensed their design to Specialized Bicycles, who incorporated the design into their FACT carbon crankset and frame which utilized a BB30 bottom bracket shell with pressed in bearings.
A headstamp is the marking on the bottom of a cartridge case designed for a firearm. It usually tells who manufactured the case. Military headstamps usually have only the year of manufacture . The left cartridge's headstamp says "FC 223 REM" which means that it was made by Federal Cartridge Co. and it is in the caliber .223 Remington. The ...
Even newer designs have the bottom bracket spindle, usually hollow and larger diameter than is possible for bottom brackets with bearings held inside the bottom bracket shell of a bike frame, for reduced weight and increased stiffness, permanently attached to the right crank (Shimano and others) or the left crank (Race Face).
Black plastic cable guide on the bottom of a Trek 5000 bottom bracket shell Metal, braze-on cable guide on the top of a bottom bracket shell. A cable guide is a fitting or part of a bicycle frame which guides a piece of bare inner bowden cable around a corner. Most multi-speed bicycles have cable guides to get the derailleur cables past the ...