enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Baseboard - Wikipedia

   en.wikipedia.org/wiki/Baseboard

   It covers the uneven edge of flooring next to the wall; protects the wall from kicks, abrasion, and furniture; and can serve as a decorative molding. [1] At its simplest, baseboard consists of a simple plank nailed, screwed or glued to the wall; however, particularly in older houses, it can be made up of a number of moldings for

3. Design of plastic components - Wikipedia

   en.wikipedia.org/wiki/Design_of_plastic_components

   Sharp Corners general design guidelines in injection molding suggest that corner radii should be at least one-half the wall thickness. It is recommended to avoid sharp corners and use generous fillets and radii whenever required. During injection molding, the molten plastic has to navigate turns or corners.

4. Crown molding - Wikipedia

   en.wikipedia.org/wiki/Crown_molding

   A compound crown molding built up out of several individual trim elements Decorative pilaster of natural cherry hardwood topped with crown molding Crown molding may be a complex build-up of multiple trim elements, in this case built-out slightly above a window with short 90-degree returns The relief on this short 90-degree return of crown molding was back-cut with a coping saw

5. Molding (decorative) - Wikipedia

   en.wikipedia.org/wiki/Molding_(decorative)

   Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]

6. Transfer molding - Wikipedia

   en.wikipedia.org/wiki/Transfer_molding

   Sharp corners are the problems with all mold based manufacturing, including casting. Specifically in transfer molding corners can break fibers that have been placed in the mold and can create voids on the inside of corners. This effect is demonstrated in Figure 3 on the right. The limiting factor in these designs is the inner corner radius. [8]

7. Coping (joinery) - Wikipedia

   en.wikipedia.org/wiki/Coping_(joinery)

   Coping or scribing is the woodworking technique of shaping the end of a moulding or frame component to neatly fit the contours of an abutting member. Joining tubular members in metalworking is also referred to as a cope, or sometimes a "fish mouth joint" or saddle joint .