Ads
related to: add dimmer switch to existing circuit board assemblyglobalindustrial.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.
Remote Device Management (RDM) is an addition to the DMX512 control protocol for stage lighting equipment, introduced in 2006. DMX512 was developed in the late 1980s as a standard protocol for lighting consoles to communicate with dimmers, but has since been used for more complex applications, including the control of intelligent lighting fixtures.
Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]
The mold may be part of the finished article and may provide shielding or heat dissipating functions in addition to acting as a mold. When the mold is removed the potted assembly is described as cast. [4] As an alternative, many circuit board assembly houses coat assemblies with a layer of transparent conformal coating rather than potting. [5]
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
That is, if the light board is in a control room that is located far from the fixtures, such as a catwalk, an RFU can be attached and an electrician or the lighting designer can bring it to a location which is close to the lights. Some of the newer and more advanced boards have RFUs that can be connected through USB or even wirelessly.
Ads
related to: add dimmer switch to existing circuit board assemblyglobalindustrial.com has been visited by 100K+ users in the past month