enow.com Web Search

  1. Ads

    related to: connecting led strips with wire

Search results

  1. Results from the WOW.Com Content Network
  2. LED strip light - Wikipedia

    en.wikipedia.org/wiki/LED_strip_light

    An LED strip, tape, or ribbon light is a flexible circuit board populated by surface-mount light-emitting diodes (SMD LEDs) and other components that usually comes with an adhesive backing. Traditionally, strip lights had been used solely in accent lighting, backlighting, task lighting, and decorative lighting applications, such as cove lighting .

  3. Light-emitting diode - Wikipedia

    en.wikipedia.org/wiki/Light-emitting_diode

    Typical current ratings range from around 1 mA to above 20 mA. LED's can be soldered to a flexible PCB strip to form LED tape popularly used for decoration. Common package shapes include round, with a domed or flat top, rectangular with a flat top (as used in bar-graph displays), and triangular or square with a flat top.

  4. LED circuit - Wikipedia

    en.wikipedia.org/wiki/LED_circuit

    Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.

  5. Electrical wiring - Wikipedia

    en.wikipedia.org/wiki/Electrical_wiring

    The first rubber-insulated cables for US building wiring were introduced in 1922 with US patent 1458803, Burley, Harry & Rooney, Henry, "Insulated electric wire", issued 1923-06-12, assigned to Boston Insulated Wire and Cable . These were two or more solid copper electrical wires with rubber insulation, plus woven cotton cloth over each ...

  6. Ribbon cable - Wikipedia

    en.wikipedia.org/wiki/Ribbon_cable

    In some cases, hobbyists strip off the wire with a fine razor, and then separate the wires before soldering them. Some hobbyists use fine sandpaper to wear away the plastic insulation from the wires. The sanding also primes the copper tracks. Then when the tinned soldering iron is touched onto the bare wire, the solder is guided into the track.

  7. Terminal (electronics) - Wikipedia

    en.wikipedia.org/wiki/Terminal_(electronics)

    Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.

  1. Ads

    related to: connecting led strips with wire