Search results
Results from the WOW.Com Content Network
Blade pitch is measured relative to the aircraft body. It is usually described as "fine" or "low" for a more vertical blade angle, and "coarse" or "high" for a more horizontal blade angle. Blade pitch is normally described as a ratio of forward distance per rotation assuming no slip. Blade pitch acts much like the gearing of the final drive of ...
The efficiency of the propeller is influenced by the angle of attack (α). This is defined as α = Φ - θ, [28] where θ is the helix angle (the angle between the resultant relative velocity and the blade rotation direction) and Φ is the blade pitch angle. Very small pitch and helix angles give a good performance against resistance but ...
A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two pitch angles
In adjustable-pitch propeller control system, the pilot has to adjust the propeller pitch angle and thus angle of attack of the propeller blades (typically with a lever) to achieve the desired propeller rotational speed. The increased pitch (blade angle of attack) increases the load on the engine and therefore slows it down, and vice versa.
An alternative design is the controllable-pitch propeller (CPP, or CRP for controllable-reversible pitch), where the blades are rotated normally to the drive shaft by additional machinery – usually hydraulics – at the hub and control linkages running down the shaft. This allows the drive machinery to operate at a constant speed while the ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
If an impeller has only a few blades (i.e a large pitch), it will result in less lift force and in a similar manner for more blades (i.e. very low pitch), there will be high drag force. Blade solidity should not be confused with rotor solidity, which is the ratio of the total area of the rotor blades to the swept area of the rotor.
What is a cutter? A dart. Hitting the fairway on a dogleg hole. The slider-fastball midpoint. What does it look like? A cutter is a fastball with a hint of a slider’s bite.