Search results
Results from the WOW.Com Content Network
In a water boiler, draft is the difference between atmospheric pressure and the pressure existing in the furnace or flue gas passage. [1] Draft can also be referred to as the difference in pressure in the combustion chamber area which results in the motion of the flue gases and the air flow.
Dieseling or engine run-on is a condition that can occur in spark-plug-ignited, gasoline-powered internal combustion engines, whereby the engine keeps running for a short period after being turned off, drawing fuel through the carburetor, into the engine and igniting it without a spark.
In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways: A flame rectification device. [2]
17. Cincinnati Bengals — Derrick Harmon, DT, Oregon. One of my favorite players in the draft, Harmon can do a lot of things effectively up front, including getting pressure on all four downs.
People hold placards outside the USAID building, after billionaire Elon Musk, who is heading President Donald Trump's drive to shrink the federal government, said work is underway to shut down the ...
Bolt Shut-off Nozzle type BHP - pneumatic or hydraulic actuation. A shut-off bolt, positioned perpendicular to the melt channel moves up and down according to actuation, and thus shuts off/opens the melt flow. This nozzle type has a single melt channel. It therefore does not require rerouting of the melt around the shut-off mechanism.
A New Jersey mother of three was crushed to death by a hippopotamus on safari in Africa, according to a lawsuit by her widower blaming the US-based tour operator for failing to warn of the danger.
A cylinder with longitudinal draft Profile view of a drafted cylinder with the draft dimension. In engineering, draft is the amount of taper for molded or cast parts perpendicular to the parting line. It can be measured in degrees or mm/mm (in/in). Consider the fabrication of a hollow plastic box, without lid.