Search results
Results from the WOW.Com Content Network
Download as PDF; Printable version; ... This article gives a list of conversion factors for several physical ... 1 micron = 10 −6 metre). Within each table, ...
The NIST document gives conversion factors correct to 7 places. Factors in bold are exact. If exact factors have more than 7 places, they are rounded and no longer exact. This convert module replaces these rounded figures with the exact figures. For example, the NIST document has 1 square mile = 2.589 988 E+06 square meters.
The NIST document gives conversion factors correct to 7 places. Factors in bold are exact. If exact factors have more than 7 places, they are rounded and no longer exact. This convert module replaces these rounded figures with the exact figures. For example, the NIST document has 1 square mile = 2.589 988 E+06 square meters.
In engineering and physics, g c is a unit conversion factor used to convert mass to force or vice versa. [1] It is defined as = In unit systems where force is a derived unit, like in SI units, g c is equal to 1.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
In diagnostic radiology, the F-factor is the conversion factor between exposure to ionizing radiation and the absorbed dose from that radiation. In other words, it converts between the amount of ionization in air ( roentgens or, in SI units , coulombs per kilogram of absorber material) and the absorbed dose in air ( rads or grays ).
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...
The first of the cooling load factors used in this method is the CLTD, or the Cooling Load Temperature Difference. This factor is used to represent the temperature difference between indoor and outdoor air with the inclusion of the heating effects of solar radiation. [1] [5] The second factor is the CLF, or the cooling load factor.