Ads
related to: usb charging cable no data output module
Search results
Results from the WOW.Com Content Network
Charging docks supply power and do not include a host device or data pins, allowing any capable USB device to charge or operate from a standard USB cable. Charging cables provide power connections, but not data. In a charge-only cable, the data wires are shorted at the device end, otherwise, the device may reject the charger as unsuitable.
Charging docks supply power, and do not include a host device or data pins, allowing any capable USB device to charge or operate from a standard USB cable. Charging cables provide power connections but not data. In a charge-only cable, the data wires are shorted at the device end; otherwise, the device may reject the charger as unsuitable.
New-to-existing cables and adapters have been defined. Some USB Type-C cables and connectors can support "USB performance at SuperSpeed USB 10 Gbps (USB 3.1) and USB Power Delivery up to 100W" [19] [20] [21] although USB Type-C cables are only required to support USB 2.0 (non-SuperSpeed) data rates and 3 A (60 W at 20 V) of current. [22]
USB On-The-Go (USB OTG or just OTG) is a specification first used in late 2001 that allows USB devices, such as tablets or smartphones, to also act as a host, allowing other USB devices, such as USB flash drives, digital cameras, mice or keyboards, to be attached to them. Use of USB OTG allows devices to switch back and forth between the roles ...
Quick Charge is a proprietary technology that can charge battery-powered devices, primarily mobile phones, at power levels exceeding the 7.5 watts (5 volts at 1.5 amps) supported by the USB BC 1.2 standard, using existing USB cables. The higher voltage available allows more power (watts) to be supplied through wires without excessive heating.
USB-C plug USB-C (SuperSpeed USB 5Gbps) receptacle on a laptop. USB-C, or USB Type-C, is a 24-pin, reversible connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, to connect to monitors, external drives, hubs/docking stations, mobile phones, and many more peripheral devices.
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
Apple Lightning to USB-A cable. Lightning is an 8-pin digital connector. Unlike the 30-pin dock connector it replaced (and USB Type-A and -B connectors), it is reversible. [24] Most Lightning devices only support USB 2.0, which has a maximum transfer speed of 480 Mbit/s or 60 MB/s. With USB 2.0, only one lane is in use at a time.
Ads
related to: usb charging cable no data output module