Search results
Results from the WOW.Com Content Network
Many ETC systems use transponders like this one to electronically debit the accounts of registered cars without their stopping. Transponder used in Chile for some expressways ETC Built-in Onboard device in a Nissan Fuga vehicle in Japan Genesis G70 vehicle with South Korea's ETC System Hi-pass Terminal A RFID MTAG used for electronic toll collection on controlled-access highways/motorways ...
A simple power entry module, the rectangular device below a red power switch in the photograph. This example consists of an IEC 60320 C14 inlet connector and fuse holder. The fuse is protected by a sliding plastic cover, which requires the power lead to be removed before it can be opened.
The Sydney Coordinated Adaptive Traffic System, abbreviated SCATS, is an intelligent transportation system that manages the dynamic (on-line, real-time) timing of signal phases at traffic signals, meaning that it tries to find the best phasing (i.e. cycle times, phase splits and offsets) for a traffic situation (for individual intersections as well as for the whole network).
A PTO at the rear end of a farm tractor A PTO (in the box at the bottom) in the center of the three-point hitch of a tractor. A power take-off or power takeoff (PTO) is one of several methods for taking power from a power source, such as a running engine, and transmitting it to an application such as an attached implement or separate machine.
An installation manual or installation guide is a technical communication document intended to instruct people how to install a particular product. An installation manual is usually written by a technical writer or other technical staff. Installation is the act of putting something in place so that it is ready for use. [1]
The sensor circuit is supplied with constant current. A distinguishing feature of the IEPE principle is that the power supply and the sensor signal are transmitted via one shielded wire. Most IEPE sensors work at a constant current between 2 and 20 mA. A common value is 4 mA. The higher the constant current the longer the possible cable length.
A remote terminal unit (RTU) is a microprocessor-controlled electronic device that interfaces objects in the physical world to a distributed control system or SCADA (supervisory control and data acquisition) system by transmitting telemetry data to a master system, and by using messages from the master supervisory system to control connected objects. [1]
The system commonly uses an analog power amplifier matched to the low impedance of the transmission loop. The transmission is normally direct rather than superimposed or modulated upon a carrier, though multi-channel systems have been implemented using modulation.