Search results
Results from the WOW.Com Content Network
In a system using segmentation, computer memory addresses consist of a segment id and an offset within the segment. [3] A hardware memory management unit (MMU) is responsible for translating the segment and offset into a physical address, and for performing checks to make sure the translation can be done and that the reference to that segment and offset is permitted.
Overlays are not a method of paging RAM to disk but merely of minimizing the program's RAM use. Subsequent architectures used memory segmentation, and individual program segments became the units exchanged between disk and RAM. A segment was the program's entire code segment or data segment, or sometimes other large data structures.
If the paging unit is enabled, addresses in a segment are now virtual addresses, rather than physical addresses as they were on the 80286. That is, the segment starting address, the offset, and the final 32-bit address the segmentation unit derived by adding the two are all virtual (or logical) addresses when the paging unit is enabled.
The 80286 added an MMU that supports segmentation, but not paging. When segmentation is enabled by turning on protected mode, the segment number acts as an index into a table of segment descriptors; a segment descriptor contains a base physical address, a segment length, a presence bit to indicate whether the segment is currently in memory ...
The x86 and x86-64 segment descriptor has the following form: [3] Where the fields stand for: Base Address Starting memory address of the segment. Its length is 32 bits and it is created from the lower part bits 16 to 31, and the upper part bits 0 to 7, followed by bits 24 to 31.
AMD-V can do virtual 8086 mode in guests, too, but it can also just run the guest in "paged real mode" using the following steps: you create a SVM (Secure Virtual Machine) mode guest with CR0.PE=0, but CR0.PG=1 (that is, with protected mode disabled but paging enabled), which is ordinarily impossible, but is allowed for SVM guests if the host ...
This will typically occur because of a programming error, and the operating system must take some action to deal with the problem. On modern operating systems, it will cause a segmentation fault signal being sent to the offending program. The lookup may also fail if the page is currently not resident in physical memory.
In computer operating systems, demand paging (as opposed to anticipatory paging) is a method of virtual memory management. In a system that uses demand paging, the operating system copies a disk page into physical memory only when an attempt is made to access it and that page is not already in memory (i.e., if a page fault occurs).