Search results
Results from the WOW.Com Content Network
Portland cement clinker is made by heating, in a cement kiln, a mixture of raw materials to a calcining temperature of above 600 °C (1,112 °F) and then a fusion temperature, which is about 1,450 °C (2,640 °F) for modern cements, to sinter the materials into clinker.
Calcium silicate hydrate (also shown as C-S-H) is a result of the reaction between the silicate phases of Portland cement and water. This reaction typically is expressed as: 2 Ca 3 SiO 5 + 7 H 2 O → 3 CaO · 2 SiO 2 · 4 H 2 O + 3 Ca(OH) 2 + 173.6 kJ. also written in cement chemist notation, (CCN) as: 2 C 3 S + 7 H → C 3 S 2 H 4 + 3 CH + heat
The later 4 phases vary among the commercial products available. MTA's design is based on Portland cement, but is not interchangeable with Portland cement construction materials. [4] It has been contrasted with Portland cement in studies. [1] Newly developed fast-set MTAs were developed based on pozzolan cement or zeolite cement.
The second raw material (materials in the rawmix other than limestone) depend on the purity of the limestone. Some of the second raw materials used are: clay, shale, sand, iron ore, bauxite, fly ash and slag. Portland cement clinker is made by heating a homogeneous mixture of raw materials in a rotary kiln at high temperature. The products of ...
Portland cement is usually made from cheap, quarried raw materials, and these usually contain substantial amounts of Cr, Mn and Fe. For example, limestones used in cement manufacture usually contain 0.3-1% Fe 2 O 3, whereas levels below 0.1% are sought in limestones for white manufacture. Typical clays used in gray cement rawmix may contain 5 ...
An example SDS, including guidance for handling a hazardous substance and information on its composition and properties. A safety data sheet (SDS), [1] material safety data sheet (MSDS), or product safety data sheet (PSDS) is a document that lists information relating to occupational safety and health for the use of various substances and products.
The company was founded in 1959 as Tanzania Portland Cement Company, producing its first bag of cement in mid-1966. It was a joint venture between Cementia AG of Switzerland, with 80 percent shareholding and the government of Tanzania, through the Tanzania Development Corporation, owning 20 percent. In 1967, the government increased its ...
Phosphogypsum is a by-product from the production of phosphoric acid by treating phosphate ore with sulfuric acid according to the following reaction: . Ca 5 (PO 4) 3 X + 5 H 2 SO 4 + 10 H 2 O → 3 H 3 PO 4 + 5 (CaSO 4 · 2 H 2 O) + HX