Search results
Results from the WOW.Com Content Network
The nanoacre is a unit of real estate on a very-large-scale integration (VLSI) chip equal to 0.00627264 sq in (4.0468564224 mm 2) or the area of a square of side length 0.0792 in (2.01168 mm). VLSI nanoacres have similar total costs to acres in Silicon Valley. [29]
An increase of $0.15 on a price of $2.50 is an increase by a fraction of 0.15 / 2.50 = 0.06. Expressed as a percentage, this is a 6% increase. While many percentage values are between 0 and 100, there is no mathematical restriction and percentages may take on other values. [4]
[23] [24] This is the same unit commonly used to measure the amount of moisture in the air, also known as the absolute humidity. [25] The SI unit used to measure particulate emissions and absolute humidity is mg/m 3. [23] [25] One grain per cubic foot is approximately 2288 mg/m 3. [note 2]
Dressed timber is often sold in lengths such as 1.8, 2.4, 3.0, and 3.6 metres, each multiples of 300 mm, approximating foot-length increments, [26] while pipes and conduits may be specified as having diameters of 12, 19, 25, and 32 mm (based on "soft" conversions of 0.5, 0.75, 1, and 1.25 inches).
The United States customary units for length did not agree with the imperial system until 1959, when one international yard was defined as 0.9144 meters and, as derived units, 1 foot (= 1 ⁄ 3 yd) as 0.3048 meter and 1 inch (= 1 ⁄ 36 yd) as 25.4 mm. The list shows the imperial and other units that have been used for track gauge definitions:
English-speaking countries also used a system of units of fluid measure, or in modern terminology volume units, based on the apothecaries' system. Originally, the terms and symbols used to describe the volume measurements of liquids were the same as or similar to those used to describe weight measurements of solids [33] (for example, the pound by weight and the fluid pint were both referred to ...
The weight per unit length diminishes by an average of approximately 20% at each step. Because the weight per unit length is related to the cross sectional area, and therefore to the square of the diameter, the diameter diminishes by approximately 10.6%:
Volumetric flow rate should not be confused with volumetric flux, as defined by Darcy's law and represented by the symbol q, with units of m 3 /(m 2 ·s), that is, m·s −1. The integration of a flux over an area gives the volumetric flow rate. The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per ...