Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
The Dana/Spicer model 53 is an automotive rear axle produced by Dana-Spicer used in medium to heavy duty truck applications. The Dana/Spicer model 53 (Dana 53) is a semi-float axle that was produced from 1947–1965, [1] both with a 53 differential and wheel ends, and with a Dana 44 differential and Dana 53 wheel ends.
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.
The ID number C300-15 is stamped on the case. The output for the front drive shaft is on the right side and the rear output in line with the input. Low range is 2.62:1. One common modification of the Dana 300 is to add oil paddles to the main shaft to prevent oil starvation of the rear bearing. The Dana 300 was used in Jeep CJs from 1980 to 1986.
Dana 35c is a newer version of Dana35. C stands for a Custom as the axle was delivered to the end user without axle brackets. The axle uses a C clip, which holds the axle shafts in the carrier. A centre pin locks the shafts in. Gear Ratio: 3.55 || 11:39 - 4.11 || 9:37 -
In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as "Twin Traction Beam" (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.
VIN on a Chinese moped VIN on a 1996 Porsche 993 GT2 VIN visible in the windshield VIN recorded on a Chinese vehicle licence. A vehicle identification number (VIN; also called a chassis number or frame number) is a unique code, including a serial number, used by the automotive industry to identify individual motor vehicles, towed vehicles, motorcycles, scooters and mopeds, as defined by the ...