Search results
Results from the WOW.Com Content Network
There was one output shaft mounted forward to the front axle (not used in 6×4 trucks) and two to the rear, with one for each rear axle. [8] Both front and rear axles were of the Timken split-type with a ratio of 6.6:1. The front axle had ball-type constant-velocity joints while the two at the rear were full-floating. [9]
An undershot wheel is a vertically mounted water wheel with a horizontal axle that is rotated by the water from a low weir striking the wheel in the bottom quarter. Most of the energy gain is from the movement of the water and comparatively little from the head.
The CCW-353 (C for 1941 design, C for conventional cab, and W for tandem rear axles) was a near identical version of the CCKW-353, that lacked its front-wheel drive, resulting in an officially purely on-road, and therefore 5-ton rated, 6×4 version of the same truck. A beam front axle was used, with the transfer case locked in high range.
The M35 started as a 1949 REO Motor Car Company design for a 2½-ton 6×6 off-road truck. This original 6-wheel M34 version with a single wheel tandem was quickly superseded by the 10-wheel M35 design with a dual tandem. The basic M35 cargo truck is rated to carry 5,000 pounds (2,300 kg) off-road or 10,000 pounds (4,500 kg) on roads.
The "ton" (907 kg) weight ratings are the payload of a basic cargo version of the truck, not of the individual version. The "wheel arrangement" designation is the number of wheels x the number of driven wheels. There are two wheels per axle, dual tires are counted as one wheel. Some series have both single and dual tire models.
All models of the M939 share a common basic chassis, cab, hood, and fenders. The basic truck is a 6×6 (three axles, six wheels, all of which are powered) heavy truck. Early M939s were rebuilds of M809 vehicle chassis with a new automatic transmission, transfer cases, cab, and hood. Suffix –A2 are new production with later model Cummins engine.
The Four-Wheel-Drive Auto Company used some Ford "C" cabs which bore the FWD emblems, and Yankee-Walter used C series cab components on some of its large airport crash trucks. In Canada, the Thibault fire truck manufacturer of Pierreville, Quebec, also used C series parts for their Custom (i.e., non-commercial chassis) trucks.
The M1000 has 40 wheels (215/75R 17.5 tires) across five axle lines, these with two half-width axles per line. Each axle has hydraulic pendular suspension, providing a 254 mm stroke, with lateral oscillation accommodating surface undulations. A hydraulic suspension system is provided on the pivoting gooseneck to equalise fifth wheel loads. The ...