Search results
Results from the WOW.Com Content Network
A steel fixer with column reinforcement steel Fixing reinforcement for foundations and walls of sewage pump station in Sacramento, California. A steel fixer (UK, ironworker or "rod buster" in the United States) is a tradesman who positions and secures steel reinforcing bars, also known as rebar, and steel mesh used in reinforced concrete on construction projects.
Plastic spacers and bar supports do not bond well with concrete and are not compatible materials. [1] Plastic has mechanical properties (holds the bar in position) but no structural properties, and is a foreign element within the construction. When the concrete is poured into the form, a small gap is created between the concrete and the plastic.
Limit rods may be used in an expansion joint design to limit the axial compression or expansion. They allow the expansion joint to move over a range according to where the nut stops are placed along the rods. Limit rods are used to prevent bellows over-extension while restraining the full pressure thrust of the system.
Morgan Construction Company has been building high-production, continuous, 2-high hot mills since 1888. These mills were designed to produce wire rod, merchant bars, small angles, skelp, sheet, bar, and billets, and were in operation in practically every country where the manufacture of steel has assumed large enough proportions to warrant this type of mill.
Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.
The caulking filler is used to prevent backfill material from flowing into the joint or crack. Non-shrink concrete backfill material that is tested as rapid set concrete patching materials is recommended for use on DBR projects. First, make two saw cuts in the pavement to outline the longitudinal sides of each dowel bar slot.
Steel failure: the rod reaches the yielding capacity then rupture occurs after development of large deformations. Concrete edge: a semi-conical fracture surface develops originating from the point of bearing up to the free surface. This type of failure occurs, for an anchor in the proximity of the edge of the concrete member.
A tie rod or tie bar (also known as a hanger rod if vertical) is a slender structural unit used as a tie and (in most applications) capable of carrying tensile loads only. It is any rod or bar-shaped structural member designed to prevent the separation of two parts, as in a vehicle. Tie rods and anchor plates in the ruins of Coventry Cathedral