Search results
Results from the WOW.Com Content Network
A full metal jacket (FMJ) bullet is a small-arms projectile consisting of a soft core (often lead) encased in an outer shell ("jacket") of harder metal, such as gilding metal, cupronickel, or, less commonly, a steel alloy. A bullet jacket usually allows higher muzzle velocities than bare lead without depositing significant amounts of metal in ...
A modern solution is to powder coat the lead projectile, encasing it in a protective skin, allowing higher velocities to be achieved without lead deposits. Jacketed lead: bullets intended for even higher-velocity applications generally have a lead core that is jacketed or plated with gilding metal, cupronickel, copper alloys, or steel; a thin ...
An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.
The initial .303 Mark I and Mk II service cartridges used a 215-grain (13.9 g), round-nosed, copper-nickel full metal jacketed bullet with a lead core. After tests determined that the service bullet had too thin a jacket when used with cordite, the Mk II bullet was introduced, with a flat base and thicker copper-nickel jacket. [12]
Bullet diameter depends on bullet type/material. Generally 0.451 in for full metal jacket bullets and 0.454 in for lead bullets. 0.50: 12.7 mm: 0.510 in, 12.95 mm: 50 BMG, 50 Action Express, 12.7×108mm, 500 S&W Magnum, 50 Beowulf, 12.7x55mm: M2 Browning machine gun and other heavy machine guns, long-range rifles typified by Barrett products.
The BEAR series is a line of hunting ammunition. The cartridges use lead-cored Full Metal Jacketed, Soft-Point (Semi-Jacketed), or Hollow Point bullets, have steel cases with Berdan primers, and use a non-corrosive propellant and primers. The sub-brands differ only in the protective coating used on the cartridge case.
7.62×39mm lead core, bi-metal copper-steel full metal jacket bullet, polymer coated steel case, non-corrosive, berdan primed; 7.62×39mm HP lead core, bi-metal copper-steel hollow point bullet, polymer coated steel case, non-corrosive, berdan primed [9] 7.62×39mm ELITE lead core, copper full metal jacket bullet, brass case, non-corrosive ...
The balle D am ammunition was followed in 1932 by balle N ammunition, which featured a lead-cored, cupro-nickel-over-steel-jacketed, pointed boat-tail bullet weighing 15.0 g (232 grains). It was thicker (8.3 mm instead of 8.17) and was held into a case that had a slightly larger neck diameter than that for the older balle D am ammunition.