Search results
Results from the WOW.Com Content Network
1 ns: The time needed to execute one machine cycle by a 1 GHz microprocessor 1 ns: The time light takes to travel 30 cm (11.811 in) 10 −6: microsecond: μs One millionth of one second 1 μs: The time needed to execute one machine cycle by an Intel 80186 microprocessor 2.2 μs: The lifetime of a muon
50 microseconds – cycle time for highest human-audible tone (20 kHz). 50 microseconds – to read the access latency for a modern solid state drive which holds non-volatile computer data. [5] 100 microseconds (0.1 ms) – cycle time for frequency 10 kHz. 125 microseconds – common sampling interval for telephone audio (8000 samples/s). [6]
The Jiffy is the amount of time light takes to travel one femtometre (about the diameter of a nucleon). The Planck time is the time that light takes to travel one Planck length. The TU (for time unit) is a unit of time defined as 1024 μs for use in engineering. The svedberg is a time unit used for sedimentation rates (usually
Metric time is the measure of time intervals using the metric system. The modern SI system defines the second as the base unit of time, and forms multiples and submultiples with metric prefixes such as kiloseconds and milliseconds. Other units of time – minute, hour, and day – are accepted for use with SI, but are not part of it
A millisecond (from milli-and second; symbol: ms) is a unit of time in the International System of Units equal to one thousandth (0.001 or 10 −3 or 1 / 1000) of a second [1] [2] or 1000 microseconds.
In some data communication standards, a time unit (TU) is equal to 1024 microseconds. [1] This unit of time was originally introduced in IEEE 802.11-1999 standard [2] and continues to be used in newer issues of the IEEE 802.11 standard. [1] In the 802.11 standards, periods of time are generally described as integral numbers of time units.
PPS signals are used for precise timekeeping and time measurement. One increasingly common use is in computer timekeeping, including NTP.Because GPS is considered a stratum-0 source, a common use for the PPS signal is to connect it to a PC using a low-latency, low-jitter wire connection and allow a program to synchronize to it.
It is the time between the gate input becoming stable and the gate output becoming stable. Manufacturers often refer to the time from the input changing to 50% of its final input level, to the output reaching 50% of its final output level; this may depend on the direction of the level change, in which case separate fall and rise delays t PHL ...