Search results
Results from the WOW.Com Content Network
The vertical stabilizer of the Airbus A310-300, first flown in 1985, was the first carbon-fiber primary structure used in a commercial aircraft; composites are increasingly used since in Airbus airliners: the horizontal stabilizer of the A320 in 1987 and A330/A340 in 1994, and the center wing-box and aft fuselage of the A380 in 2005. [3]
The vertical stabilizer is the fixed vertical surface of the empennage. A vertical stabilizer or tail fin [1] [2] is the static part of the vertical tail of an aircraft. [1] The term is commonly applied to the assembly of both this fixed surface and one or more movable rudders hinged to it. Their role is to provide control, stability and trim ...
The vertical tail structure has a fixed front section called the vertical stabiliser, used to control yaw, which is movement of the fuselage right to left motion of the nose of the aircraft. The rear section of the vertical fin is the rudder , a movable aerofoil that is used to turn the aircraft's nose right or left.
Near Mora: [7] loss of vertical stabilizer [8] 1964-01-04 1964 B-57 crash Dayton, United States NRB-57 Canberra: Mis-management of fuel system, causing CofG to be beyond its safe rearward limit 2 Both wings failed 1964-01-10 B-52 flight test of vertical stabilizer New Mexico, United States B-52 Stratofortress: Unknowingly exceeded design ...
A flying wing may have various small protuberances such as pods, nacelles, blisters, booms, or vertical stabilizers. Similar aircraft designs, that are not technically flying wings, are sometimes casually referred to as such. These types include blended wing body aircraft and lifting body aircraft, which have a fuselage and no definite wings.
Nose, wing and ventral strakes Vortices over the wing strakes of an F/A-18E Super Hornet. In aviation, a strake is an aerodynamic surface generally mounted on the fuselage of an aircraft to improve the flight characteristics either by controlling the airflow (acting as large vortex generators) or by a simple stabilising effect.
Historically, though, there is a subtle difference between the two terms. If the longitudinal members in a fuselage are few in number (usually 4 to 8) and run all along the fuselage length, then they are called "longerons". The longeron system also requires that the fuselage frames be closely spaced (about every 4 to 6 in or 10 to 15 cm).
Examples of sideforce-generating surfaces are the vertical stabilizer, rudder, and parts of the fuselage. When an aircraft is in a sideslip, these surfaces generate sidewards lift forces. If the surface is above or below the center of gravity, the sidewards forces generate a rolling moment. This rolling moment caused by sideslip is dihedral ...