Search results
Results from the WOW.Com Content Network
For now only OCPP 1.6 can be fully tested and certified. OCPP versions older than OCPP 1.6 (such as OCPP 0.7, OCPP 1.2, and OCPP 1.5) as well as OCPP 2.0 are not covered under the current OCPP certification program. Open Charge Alliance has defined a set of test procedures and test plans for the certification compliance.
ISO 15118 is one of the International Electrotechnical Commission's (IEC) group of standards for electric road vehicles and electric industrial trucks, and is the responsibility of Joint Working Group 1 (JWG1 V2G) of IEC Technical Committee 69 (TC69) [3] together with subcommittee 31 (SC31) [4] of the International Organization for Standardization's (ISO) Technical Committee 22 (TC22) [5] on ...
Provides warnings if tagged parameters do not match code, parsed parameters included in XML output and Doxygen-style tagfile (-D flag in 8.7). Partial C preprocessor support with -p flag. Support for #if/#ifdef control over documentation inclusion using the -D and -U command-line flags. Imagix 4D: customizable through style sheets and CSS
Version 1.1 of the OpenFlow protocol was released on 28 February 2011, and new development of the standard was managed by the ONF. [13] In December 2011, the ONF board approved OpenFlow version 1.2 and published it in February 2012. [14]
802.1X-2001 defines two logical port entities for an authenticated port—the "controlled port" and the "uncontrolled port". The controlled port is manipulated by the 802.1X PAE (Port Access Entity) to allow (in the authorized state) or prevent (in the unauthorized state) network traffic ingress and egress to/from the controlled port.
The Lightweight Extensible Authentication Protocol (LEAP) method was developed by Cisco Systems prior to the IEEE ratification of the 802.11i security standard. [3] Cisco distributed the protocol through the CCX (Cisco Certified Extensions) as part of getting 802.1X and dynamic WEP adoption into the industry in the absence of a standard.
Although sometimes referred to as "6502C" in Atari documentation, this is not the same as the official 6502C and the chip itself is never marked as such. [84] MOS 6503: Reduced memory addressing capability (4 KB) and no RDY input, in a 28-pin DIP package (with the phase 1 (OUT), SYNC, redundant Vss, and SO pins of the 6502 also omitted). [86 ...
The International Organization for Standardization (ISO / ˈ aɪ s oʊ /; [3] French: Organisation internationale de normalisation; Russian: Международная организация по стандартизации) is an independent, non-governmental, international standard development organization composed of representatives from the national standards organizations of member ...