enow.com Web Search

  1. Ads

    related to: electronic main water shut off valve leak

Search results

  1. Results from the WOW.Com Content Network
  2. Valve leakage - Wikipedia

    en.wikipedia.org/wiki/Valve_leakage

    The importance of valve leakage depends on what the valve is controlling. For example, a dripping tap is less significant than a leak from a six-inch pipe carrying high-pressure radioactive steam. In the United States, the American National Standards Institute specifies six different leakage classes, with "leakage" defined in terms of the full ...

  3. Shutdown valve - Wikipedia

    en.wikipedia.org/wiki/Shutdown_valve

    A shutdown valve (also referred to as SDV or emergency shutdown valve, ESV, ESD, or ESDV; or safety shutoff valve) is an actuated valve designed to stop the flow of a hazardous fluid upon the detection of a dangerous event. This provides protection against possible harm to people, equipment or the environment.

  4. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Cone valves or ball valves are another alternative. These are commonly found as the service shut-off valves in more-expensive water systems and usually found in gas taps (and, incidentally, the cask beer taps referred to above). They can be identified by their range of motion—only 90°—between fully open and closed.

  5. Leak detection - Wikipedia

    en.wikipedia.org/wiki/Leak_detection

    A leak appearing within an analytic region (a rule added to the camera) is immediately analyzed for its attributes, including thermal temperature, size, and behaviour (e.g. spraying, pooling, spilling). When a leak is determined to be valid based on set parameters, an alarm notification with leak video is generated and sent to a monitoring station.

  6. Water detector - Wikipedia

    en.wikipedia.org/wiki/Water_detector

    A water detector is an electronic device that is designed to detect the presence of water for purposes such as to provide an alert in time to allow the prevention of water leakage. A common design is a small cable or device that lies flat on a floor and relies on the electrical conductivity of water to decrease the resistance across two contacts.

  7. Water hammer - Wikipedia

    en.wikipedia.org/wiki/Water_hammer

    To keep water hammer low, pipe-sizing charts for some applications recommend flow velocity at or below 1.5 m/s (4.9 ft/s). Fit slowly closing valves. Toilet fill valves are available in a quiet fill type that closes quietly. Non-slam check valves do not rely on fluid flow to close and will do so before the water flow reaches significant velocity.

  1. Ads

    related to: electronic main water shut off valve leak