enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Marman clamp - Wikipedia

   en.wikipedia.org/wiki/Marman_clamp

   Aerospace pipe fittings with flanges for Marman clamps: a semi-rigid bleed air duct from a jet engine (left) and a semi-flexible fuel hose (right). A common use for Marman clamps is as quick-disconnect connectors in flexible aircraft fuel lines. [2]

3. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.

4. Air-line fitting - Wikipedia

   en.wikipedia.org/wiki/Air-line_fitting

   Fittings are commonly referred to by their manufacturer name/series, i.e., "Rectus 25" for the common European standard. ... German/Walther 6 LP 6 200.05 52 LP-006 ...

5. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   Galvanized rigid conduit (GRC) is galvanized steel tubing, with a tubing wall that is thick enough to allow it to be threaded. Its common applications are in commercial and industrial construction. [1] It is designed to protect wire and connectors. Intermediate metal conduit (IMC) is a steel tubing heavier than EMT but lighter than RMC. It may ...

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).

7. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   Rigid may be required for certain areas and additionally, vapor-lock fittings may be required in areas where a fire or explosion hazard is present (such as gas stations, chemical factories, grain silos, etc.) PVC can be used where wire is run underground or where concrete will be poured. A duct bank is usually made of multiple PVC conduits ...