Search results
Results from the WOW.Com Content Network
A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
A simple miter gauge. A miter gauge is a device used for holding workpieces at a set angle while being cut on table saws, band saws or sanded on stationary disk sanders.The miter gauge slides in a slot on the worktable (known as a miter slot) on the machine being used.
Miter squares are usually made from two fixed parts, a stock and a blade (sometimes called a tongue). The blade on a modern factory-made miter square is typically a thin piece of metal which is fixed at 45° onto or into the stock, forming a 'T' shape. The stock is usually much thicker than the blade and is made from wood, metal or plastic.
The term is also used currently to refer to a thin, flexible saw used to free sashes that have been painted shut. Carcass saw – an in-between of a tenon saw and a dovetail saw. Dovetail saw – a small backsaw used to cut dovetails. These saws will usually have a higher number of teeth per inch (around 15 - 20 T.P.I.) with teeth sharpened in ...
Miter gears. Mitre gears are a special case of bevel gears that have equal numbers of teeth. The shafts are positioned at right angles from each other, and the gears have matching pitch surfaces and angles, with a conically-shaped pitch surface. [2] Mitre gears are useful for transmitting rotational motion at a 90-degree angle with a 1:1 ratio.
The bare blade of a Japanese sword without the handle or hilt. A blade is the sharp, cutting portion of a tool, weapon, or machine, specifically designed to puncture, chop, slice, or scrape surfaces or materials. Blades are typically made from materials that are harder than those they are intended to cut.
A diagram of a katana and koshirae with components identified. Fuchi (縁): The fuchi is a hilt collar between the tsuka and the tsuba.; Habaki (鎺): The habaki is a wedge-shaped metal collar used to keep the sword from falling out of the saya and to support the fittings below; fitted at the ha-machi and mune-machi which precede the nakago.