Search results
Results from the WOW.Com Content Network
For common tape measurements, the tape used is a steel tape with coefficient of thermal expansion C equal to 0.000,011,6 units per unit length per degree Celsius change. This means that the tape changes length by 1.16 mm per 10 m tape per 10 °C change from the standard temperature of the tape.
In thermodynamics, the Volume Correction Factor (VCF), also known as Correction for the effect of Temperature on Liquid (CTL), is a standardized computed factor used to correct for the thermal expansion of fluids, primarily, liquid hydrocarbons at various temperatures and densities. [1]
Ampex tape recorders in the 1950s achieved 60 dB in practical usage, [26] In the 1960s, improvements in tape formulation processes resulted in 7 dB greater range, [28]: 158 and Ray Dolby developed the Dolby A-Type noise reduction system that increased low- and mid-frequency dynamic range on magnetic tape by 10 dB, and high-frequency by 15 dB ...
The first of the cooling load factors used in this method is the CLTD, or the Cooling Load Temperature Difference. This factor is used to represent the temperature difference between indoor and outdoor air with the inclusion of the heating effects of solar radiation. [1] [5] The second factor is the CLF, or the cooling load factor.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
For all types of tape, MOL reaches a maximum in the 125–800 Hz area, while dropping off below 125 Hz and above 800 Hz. [13] The maximum output of Type I tape at 40 Hz is 3–5 dB lower than MOL 400, [14] while in Type IV tapes it is 6–7 dB lower. [15]
The adhesive is pressure-sensitive, meaning that as soon as you stick it and apply pressure, it'll create an airtight and watertight seal around even the draftiest spots of your home.
The first commonly available increase in tape length resulted from a reduction in backing thickness from 1.5 to 1.0 mil (38 to 25 μm) resulting in a total thickness reduction from 42 to 35 μm (1.7 to 1.4 mils), which allowed 3,600 ft (1,100 m), 1,800 ft (550 m), and 900 ft (270 m) tapes to fit on ten-and-a-half-, seven-, and five-inch reels respectively.