Search results
Results from the WOW.Com Content Network
Ice dam forming on slate roof. An ice dam is an ice build-up on the eaves of sloped roofs of heated buildings that results from melting snow under a snow pack reaching the eave and freezing there. Freezing at the eave impedes the drainage of meltwater, which adds to the ice dam and causes backup of the meltwater, which may cause water leakage ...
The dominant cause of soil displacement in frost heaving is the development of ice lenses. During frost heave, one or more soil-free ice lenses grow, and their growth displaces the soil above them. These lenses grow by the continual addition of water from a groundwater source that is lower in the soil and below the freezing line in the soil.
As water permeates the ice, it becomes segregated into separate pieces of ice in the form of lenses, ribbons, needles, layers or strands of ice. [4] Needle ice is commonly found along stream banks or soil terraces. It is also found by gaps around stones and others areas of patterned ground. The variety of soil properties also affects where it ...
A "greenhouse Earth" is a period during which no continental glaciers exist anywhere on the planet. [6] Additionally, the levels of carbon dioxide and other greenhouse gases (such as water vapor and methane) are high, and sea surface temperatures (SSTs) range from 28 °C (82.4 °F) in the tropics to 0 °C (32 °F) in the polar regions. [7]
The wall of this ice tube is about 0.1 mm (0.004 in) and the width 5 mm (0.2 in). As a result of this growth process, the interior of a growing icicle is liquid water. The growth of an icicle both in length and in width can be calculated and is a complicated function of air temperature, wind speed, and the water flux into the icicle. [3]
Ice jacking is a continuous process that occurs during the winter in areas near lakes. The process starts when the ice begins to crack. When water then fills in those gaps, the process repeats and continues until there is a wall of ice surrounding the lake's shoreline, sometimes reaching up to three feet.
The three main types of ground frost are radiation frost (), advection frost (advection hoar frost) and evaporation frost.The latter is a rare type which occurs when surface moisture evaporates into drier air causing its temperature at the surface to fall at or under the freezing point of water. [1]
Internal deformation occurs when the weight of the ice causes the deformation of ice crystals. This takes place most readily near the glacier bed, where pressures are highest. There are glaciers that primarily move via sliding, glacial quakes, and others that move almost entirely through deformation.