Search results
Results from the WOW.Com Content Network
The company sells Baldor-Reliance and ABB branded industrial electric motors. Products are available in both IEC and NEMA configurations and range from fractional to 100,000 horsepower. The company also sells the Dodge brand of mechanical power transmission products, including mounted bearings, enclosed gearing, couplings, sheaves, and bushings.
Short title: Author: Date and time of digitizing: 12:53, 19 January 2001: Software used: Adobe PageMaker 6.5: File change date and time: 07:32, 9 October 2008
Automatic lubrication system installed on computer numerical control machine. Automatic lubrication systems (ALS), also known as centralized lubrication systems (CLS), are mechanical devices used in industrial machines and engines to apply specified quantities of a lubricant to distribution points while the machine is operating.
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
Lithium-based grease has a dropping point at 190 to 220 °C (374 to 428 °F). However the maximum usable temperature for lithium-based grease is 120 °C. The amount of grease in a sample can be determined in a laboratory by extraction with a solvent followed by e.g. gravimetric determination. [6]
Lubrication mechanisms such as fluid-lubricated systems are designed so that the applied load is partially or completely carried by hydrodynamic or hydrostatic pressure, which reduces solid body interactions (and consequently friction and wear). Depending on the degree of surface separation, different lubrication regimes can be distinguished.
These engines were designed to have a total-loss lubrication system, with the motor oil held in a separate tank from the fuel in the vehicle, and not pre-mixed with it as with two-cycle engines, but mixed within the engine instead while running. Castor oil was often used because it lubricates well at the high temperatures found in air-cooled ...
The displacement lubricator was a useful stop-gap but had the disadvantage that it was difficult to accurately control over the rate of oil feed and lubrication was only supplied when the engine was doing work (when a locomotive is coasting with the regulator closed, no steam is present to operate the lubricator).