Search results
Results from the WOW.Com Content Network
Wireless LAN (WLAN) channels are frequently accessed using IEEE 802.11 protocols. The 802.11 standard provides several radio frequency bands for use in Wi-Fi communications, each divided into a multitude of channels numbered at 5 MHz spacing (except in the 45/60 GHz band, where they are 0.54/1.08/2.16 GHz apart) between the centre frequency of the channel.
HYSYS is able to perform many of the core calculations of chemical engineering, including those concerned with mass balance, energy balance, vapor-liquid equilibrium, heat transfer, mass transfer, chemical kinetics, fractionation, and pressure drop. [2] HYSYS is used extensively in industry and academia for steady-state and dynamic simulation ...
Most domestic microwave ovens operate by emitting a very high power signal in the 2.4 GHz band. Older devices have poor shielding, [13] and often emit a very "dirty" signal over the entire 2.4 GHz band. [a] This can cause considerable difficulties to Wi-Fi and video [15] transmission, resulting in reduced range or complete blocking of the signal.
Figure 3 (Ref. needed) shows a schematic of a vibration isolation system consisting of a weighted platform supported by a single six-DOF isolator incorporating the isolators of Figures 1 and 2 (Figures 1 and 2 are missing). Flexures are used in place of the hinged bars shown in Figure 1. A tilt flexure serves as the tilt-motion isolator.
In order to reduce the maximum force on the motor mounts as the motor operates over a range of speeds, a smaller mass, m 2, is connected to m 1 by a spring and a damper, k 2 and c 2. F 1 is the effective force on the motor due to its operation. Response of the system excited by one unit of force, with (red) and without (blue) the 10% tuned mass ...
IEEE 802.11a/g/n, operating in the 2.4 and 5 GHz bands, specifies per-stream airside data rates ranging from 6 to 54 Mbit/s. If both devices can use "HT mode" (added with 802.11n ), the top 20 MHz per-stream rate is increased to 72.2 Mbit/s, with the option of data rates between 13.5 and 150 Mbit/s using a 40 MHz channel.
IEEE 802.11a-1999 or 802.11a was an amendment to the IEEE 802.11 wireless local network specifications that defined requirements for an orthogonal frequency-division multiplexing (OFDM) communication system.
In the US, FCC part 15 on unlicensed spread spectrum systems in the 902–928 MHz and 2.4 GHz bands permits more power than is allowed for non-spread-spectrum systems. Both FHSS and direct-sequence spread-spectrum (DSSS) systems can transmit at 1 watt, a thousandfold increase from the 1 milliwatt limit on non-spread-spectrum systems.