Search results
Results from the WOW.Com Content Network
[citation needed] Previously, terrestrial television stations used DTMF tones to control remote transmitters. [7] In IP telephony, DTMF signals can also be delivered as either in-band or out-of-band tones, [8] or even as a part of signaling protocols, [9] as long as both endpoints agree on a common approach to adopt.
Multifrequency signaling is a technological precursor of dual-tone multi-frequency signaling (DTMF, Touch-Tone), which uses the same fundamental principle, but was used primarily for signaling address information and control signals from a user's telephone to the wire-center's Class-5 switch. DTMF uses a total of eight frequencies.
Pressing a single key of a traditional analog telephone keypad produces a telephony signaling event to the remote switching system. For touchtone service, the signal is a dual-tone multi-frequency signaling tone consisting of two simultaneous pure tone sinusoidal frequencies. The row in which the key appears determines the low-frequency ...
Some decoders may require much longer-duration digits. DTMF digits consist of paired tones: a row tone and a column tone. The levels of row and column tones must be similar in order for a decoder to interpret them reliably. Radios with DTMF decoders may monitor all system traffic or remain muted until called, depending on the system design.
Symbols in the DTMF and MF alphabets are sent as tone pairs; DTMF selects one tone from a "high" group and one from a "low" group, while MF selects its two tones from a common set. DTMF and MF use different tone frequencies largely to keep end users from interfering with inter-office signaling.
Some central office switches in the United States, notably older GTD-5 EAX systems, utilize a single frequency tone, 480 Hz, known as High Tone for this purpose. In either case, the tone is substantially louder than any other signal transmitted over a copper POTS circuit; loud enough to be heard across a room from an unused off-hook telephone.
E&M line signaling is however usually paired with DTMF register signaling. By contrast, the L1 signaling system (which typically employs a 2280 Hz tone of various durations) is an in-band channel-associated signaling system as was the SF 2600 hertz system formerly used in the Bell System .
Blue box - a device that was used to bypass the normal long-distance call switching tones typically used to obtain free calls. C ... DTMF: dual-tone multi-frequency FDM: