Search results
Results from the WOW.Com Content Network
Full width at half maximum. In a distribution, full width at half maximum (FWHM) is the difference between the two values of the independent variable at which the dependent variable is equal to half of its maximum value. In other words, it is the width of a spectrum curve measured between those points on the y-axis which are half the maximum ...
If the maximum gain is 0 dB, the 3 dB bandwidth is the frequency range where attenuation is less than 3 dB. 3 dB attenuation is also where power is half its maximum. This same half-power gain convention is also used in spectral width, and more generally for the extent of functions as full width at half maximum (FWHM).
where f r is the resonant frequency Δf is the resonance width or full width at half maximum (FWHM) i.e. the bandwidth over which the power of vibration is greater than half the power at the resonant frequency, ω r = 2πf r is the angular resonant frequency, and Δω is the angular half-power bandwidth. Under this definition, Q is the ...
In fiber-optic communication applications, the usual method of specifying spectral width is the full width at half maximum (FWHM). This is the same convention used in bandwidth, defined as the frequency range where power drops by less than half (at most −3 dB). The FWHM method may be difficult to apply when the spectrum has a complex shape.
Early uses of the term Nyquist frequency, such as those cited above, are all consistent with the definition presented in this article.Some later publications, including some respectable textbooks, call twice the signal bandwidth the Nyquist frequency; [6] [7] this is a distinctly minority usage, and the frequency at twice the signal bandwidth is otherwise commonly referred to as the Nyquist rate.
Spectral bandwidth is defined as the width of the triangle at the points where the light has reached half the maximum value (full width at half maximum, abbreviated as FWHM). A typical spectral bandwidth might be one nanometer; however, different values can be chosen to meet the need of analysis.
The half-power point is the point at which the output power has dropped to half of its peak value; that is, at a level of approximately −3 dB. [1] [a]In filters, optical filters, and electronic amplifiers, [2] the half-power point is also known as half-power bandwidth and is a commonly used definition for the cutoff frequency.
Both downsampling and decimation can be synonymous with compression, or they can describe an entire process of bandwidth reduction and sample-rate reduction. [ 1 ] [ 2 ] When the process is performed on a sequence of samples of a signal or a continuous function, it produces an approximation of the sequence that would have been obtained by ...