Search results
Results from the WOW.Com Content Network
The tieback-deadman structure resists forces that would otherwise cause the wall to lean, as for example, when a seawall is pushed seaward by water trapped on the landward side after a heavy rain. Tiebacks are drilled into soil using a small diameter shaft, and usually installed at an angle of 15 to 45 degrees.
Single helix earth anchors Guyed mast anchor. An earth anchor is a device designed to support structures, most commonly used in geotechnical and construction applications. Also known as a ground anchor, percussion driven earth anchor or mechanical anchor, it may be impact driven into the ground or run in spirally, depending on its design and intended force-resistance characteristics.
A A-grade Also aid climbing grade. The technical difficulty grading system for aid climbing (both for "original" and an adapted version for "new wave"), which goes: A0, A1, A2, A3, A4, A5 and up to A6 (for "new wave"). See C-grade. Abalakov thread Abalakov thread Also V-thread. A type of anchor used in abseiling especially in winter and in ice climbing. ABD Also assisted braking device. A term ...
When selecting an anchor, consider the element formwork and the ease of placement and securing of the anchor prior and during the pouring of the concrete. For example, some of the anchors shown in figures 4-6, can be placed into thin wall elements as the anchor chair maintains the position relative to the element thickness.
Deadman or Deadman's may refer to: "Deadman" or "dead man", are alternative terms for a dead man's switch "Deadman's foot" is another name for a Salamander in metallurgy "Deadman anchor" is a buried object (log, concrete, block, etc.) used to anchor objects during construction, mooring, or other activities.
Modern forms are the plate anchor, in which the guy is attached to a rod with an eyelet extending from the center of a steel plate buried diagonally, perpendicular to the angle of the guy. In the concrete anchor, a diagonal rod with an eyelet extending in the guy direction is cemented into a hole filled with steel reinforced concrete.
The tension failure loads predicted by the CCD method fits experimental results over a wide range of embedment depth (e.g. 100 – 600 mm). [2] Anchor load bearing capacity provided by ACI 349 does not consider size effect, thus an underestimated value for the load-carrying capacity is obtained for large embedment depths.
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...