Ad
related to: sonet network configuration
Search results
Results from the WOW.Com Content Network
The electrical interface, often a 50-ohm coaxial cable, sends SONET TL1 commands from a local management network physically housed in the central office where the SONET network element is located. This is for local management of that network element and, possibly, remote management of other SONET network elements.
Several type of networks can be used to transport the synchronous signal and could be combined indeed. Some of these networks are T1/E1, SONET/SDH and any rate, and SyncE. However legacy Ethernet is not suitable for transmitting synchronization signals. This is important because if the signal crosses a legacy Ethernet island then the ...
Ethernet Over SDH (EoS or EoSDH) or Ethernet over SONET refers to a set of protocols which allow Ethernet traffic to be carried over synchronous digital hierarchy networks in an efficient and flexible way. The same functions are available using SONET.
A self-healing ring, or SHR, is a telecommunications term for loop network topology, a common configuration in telecommunications transmission systems. Like roadway and water distribution systems, a loop or ring is used to provide redundancy. SDH, SONET and WDM systems are often configured in self-healing rings.
In telecommunications, subnetwork connection protection (SNCP), is a type of protection mechanism associated with synchronous optical networks such as synchronous digital hierarchy (SDH). SNCP is a dedicated (1+1) protection mechanism for SDH network spans which may be deployed in ring, point to point or mesh topologies. [1]
OC-768 SONET interfaces have been available with short-reach optical interfaces from Cisco since 2006. Infinera made a field trial demonstration data transmission on a live production network involving the service transmission of a 40 Gbit/s OC-768/STM-256 service over a 1,969 km terrestrial network spanning Europe and the U.S.
Packet over SONET/SDH, abbreviated POS, is a communications protocol for transmitting packets in the form of the Point to Point Protocol (PPP) over SDH or SONET, which are both standard protocols for communicating digital information using lasers or light emitting diodes (LEDs) over optical fibre at high line rates. POS is defined by RFC 2615 ...
VT1.5 is a type of virtual tributary in SONET.. SONET bandwidth is defined in multiples of an OC-1/STS-1, each of which can transport up to 51.84 Mbit/s. However, it is frequently desirable to address much smaller portions of bandwidth.
Ad
related to: sonet network configuration