Search results
Results from the WOW.Com Content Network
{{convert|4|ft|0|adj=mid|-long}} → 4-foot-long (1 m) The last example works because " |0 " sets the output precision to zero, and convert does not look for an output unit once the precision has been specified because a precision is always given after the output unit, if any.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
By {{Convert}} default, the conversion result will be rounded either to precision comparable to that of the input value (the number of digits after the decimal point—or the negative of the number of non-significant zeroes before the point—is increased by one if the conversion is a multiplication by a number between 0.02 and 0.2, remains the ...
This decimal format can also represent any binary fraction a/2 m, such as 1/8 (0.125) or 17/32 (0.53125). More generally, a rational number a / b , with a and b relatively prime and b positive, can be exactly represented in binary fixed point only if b is a power of 2; and in decimal fixed point only if b has no prime factors other than 2 and/or 5.
The nibble is used to describe the amount of memory used to store a digit of a number stored in binary-coded decimal format, or to represent a single hexadecimal digit. Less commonly, 'nibble' may be used for any contiguous portion of a byte of specified length, e.g. "6-bit nibble"; this usage is most likely to be encountered in connection with ...
That is, the value of an octal "10" is the same as a decimal "8", an octal "20" is a decimal "16", and so on. In a hexadecimal system, there are 16 digits, 0 through 9 followed, by convention, with A through F. That is, a hexadecimal "10" is the same as a decimal "16" and a hexadecimal "20" is the same as a decimal "32".
Decimals may sometimes be identified by a decimal separator (usually "." or "," as in 25.9703 or 3,1415). [3] Decimal may also refer specifically to the digits after the decimal separator, such as in "3.14 is the approximation of π to two decimals". Zero-digits after a decimal separator serve the purpose of signifying the precision of a value.
The system was slightly revised in 1735. In 1855, a decimal reform was instituted that defined a new Swedish inch as 1 ⁄ 10 Swedish foot (2.96 cm or 1.17 inches). Up to the middle of the 19th century, there was a law allowing the imposition of the death penalty for falsifying weights or measures.