Ads
related to: collet chuck #2 morse taper reamer bitstoolots.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.
The Morse taper is a common machine taper frequently used in drills, lathes and small milling machines. Chucks for drilling usually use a Morse taper and can be removed to accommodate Morse taper drill bits. Morse taper collet sets usually employ ER collets in an adaptor to suit the Morse taper.
Collets can also be obtained to fit Morse or Brown and Sharpe taper sockets. Typically collets offer higher levels of precision and accuracy than self-centering chucks, and have a shorter setting up time than independent-jaw chucks. The penalty is that most collets can only accommodate a single size of workpiece.
No. 3 morse taper reamer. A morse taper reamer is used manually to finish morse taper sleeves. These sleeves are a tool used to hold machine cutting tools or holders in the spindles of machines such as a drill or milling machine. The reamer shown is a finishing reamer.
The Morse taper twist drill bits pictured right are used in metalworking. The full range of tapers is from 0 to 7. The Morse taper allows the bit to be mounted directly into the spindle of a drill, lathe tailstock, or (with the use of adapters) into the spindle of milling machines.
The smaller top item is an insert, the middle shows another three-fluted counterbore insert, assembled in the holder. The shank of this holder is a Morse taper, although there are other machine tapers that are used in the industry. The lower counterbore is designed to fit into a drill chuck, and being smaller, is economical to make as one piece.
The spindle runs in precision bearings and is fitted with some means of attaching workholding devices such as chucks or faceplates. This end of the spindle usually also has an included taper, frequently a Morse taper, to allow the insertion of hollow tubular (Morse standard) tapers to reduce the size of the tapered hole, and permit use of centers.
The number refers to the Association for Manufacturing Technology (formerly the National Machine Tool Builders Association (NMTB)) taper size of the tool. A CAT-40 toolholder A boring head on a Morse taper shank. An improvement on CAT Tooling is Bridgeport Taper (BT) Tooling, which looks similar and can easily be confused with CAT tooling.
Ads
related to: collet chuck #2 morse taper reamer bitstoolots.com has been visited by 10K+ users in the past month