enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.

3. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

4. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   Collets can also be obtained to fit Morse or Brown and Sharpe taper sockets. Typically collets offer higher levels of precision and accuracy than self-centering chucks, and have a shorter setting up time than independent-jaw chucks. The penalty is that most collets can only accommodate a single size of workpiece.

5. Milling (machining) - Wikipedia

   en.wikipedia.org/wiki/Milling_(machining)

   The number refers to the Association for Manufacturing Technology (formerly the National Machine Tool Builders Association (NMTB)) taper size of the tool. A CAT-40 toolholder A boring head on a Morse taper shank. An improvement on CAT Tooling is Bridgeport Taper (BT) Tooling, which looks similar and can easily be confused with CAT tooling.

6. Talk:Machine taper - Wikipedia

   en.wikipedia.org/wiki/Talk:Machine_taper

   Morse taper is inch-based and should be defined as such. 216.152.18.131 17:17, 3 September 2020 (UTC) I was puzzled by this, too. It appears to date nearly the creation of this article. In May 2005 DerrickOswald added the Morse taper dimensions to this article, and they were the only actual dimensions in it (the article was stubbed in March of ...

7. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   No. 3 morse taper reamer. A morse taper reamer is used manually to finish morse taper sleeves. These sleeves are a tool used to hold machine cutting tools or holders in the spindles of machines such as a drill or milling machine. The reamer shown is a finishing reamer.