enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fishing tackle - Wikipedia

   en.wikipedia.org/wiki/Fishing_tackle

   A fishing reel is a device used for the deployment and retrieval of a fishing line using a spool mounted on an axle. Fishing reels are traditionally used in angling. They are most often used in conjunction with a fishing rod, though some specialized reels are mounted on crossbows or to boat gunwales or transoms. The earliest known illustration ...

3. Fishing reel - Wikipedia

   en.wikipedia.org/wiki/Fishing_reel

   Parts of a spinning reel: 1: Pick up or bail 2: Reel seat 3: Reel foot 4: Handle 5: Support arm 6: Anti-reverse lever 7: Skirted spool 8: Fishing line 9: Drag adjustment knob A fishing reel is a hand- cranked reel used in angling to wind and stow fishing line , [ 1 ] typically mounted onto a fishing rod , but may also be used on compound bows ...

4. Casting (fishing) - Wikipedia

   en.wikipedia.org/wiki/Casting_(fishing)

   Casting (known as Casting Sport) is also a sport adjunct to fishing, much as shooting is to hunting. The sport is supervised by the International Casting Sport Federation [ 4 ] (ICSF) which was founded in 1955 and as of April 2014 has member associations in 31 countries.

5. Fishing rod - Wikipedia

   en.wikipedia.org/wiki/Fishing_rod

   At its most basic form, a fishing rod is a straight rigid stick/pole with a line fastened to one end (as seen in traditional bamboo rod fishing such as Tenkara fishing); however, modern rods are usually more elastic and generally have the line stored in a reel mounted at the rod handle, which is hand-cranked and controls the line retrieval, as ...

6. Fly fishing tackle - Wikipedia

   en.wikipedia.org/wiki/Fly_fishing_tackle

   Fly line is typically attached to a length of braided or gelspun line wound on the fly reel known as backing. The length and breaking strength of the backing required depends on the overall line capacity of the reel and the type of fish being sought. Backing may be as short as a few yards up to hundreds of yards if the reel has the capacity.

7. Draft (engineering) - Wikipedia

   en.wikipedia.org/wiki/Draft_(engineering)

   In engineering, draft is the amount of taper for molded or cast parts perpendicular to the parting line. It can be measured in degrees or mm/mm (in/in). Consider the fabrication of a hollow plastic box, without lid. Once the plastic has hardened around the mold, the mold must be removed. As the plastic hardens, it may contract slightly.

8. Parting line - Wikipedia

   en.wikipedia.org/wiki/Parting_line

   A parting line, in industrial casting of molds, is the border line between the two halves of the mold (known as the “core” and the “cavity.”), which draft direction change at here. One can check the parting line in the mould or product which divides the two half. It is sometimes a starting point for the mold parting surface.

9. Pattern (casting) - Wikipedia

   en.wikipedia.org/wiki/Pattern_(casting)

   For the production of gray iron, ductile iron and steel castings, sand casting remains the most widely used process. For aluminum castings, sand casting represents about 12% of the total tonnage by weight (surpassed only by die casting at 57%, and semi-permanent and permanent mold at 19%; based on 2006 shipments). The exact process and pattern ...