enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...

3. Stub (electronics) - Wikipedia

   en.wikipedia.org/wiki/Stub_(electronics)

   Stubs can be constructed with any type of transmission line: parallel conductor line (where they are called Lecher lines), coaxial cable, stripline, waveguide, and dielectric waveguide. Stub circuits can be designed using a Smith chart, a graphical tool which can determine what length line to use to obtain a desired reactance.

4. Waveguide (radio frequency) - Wikipedia

   en.wikipedia.org/wiki/Waveguide_(radio_frequency)

   In radio-frequency engineering and communications engineering, a waveguide is a hollow metal pipe used to carry radio waves. [1] This type of waveguide is used as a transmission line mostly at microwave frequencies, for such purposes as connecting microwave transmitters and receivers to their antennas, in equipment such as microwave ovens, radar sets, satellite communications, and microwave ...

5. Antenna feed - Wikipedia

   en.wikipedia.org/wiki/Antenna_feed

   Because of the cost and maintenance waveguide entails, microwave antennas often have the output stage of the transmitter or the RF front end of the receiver located at the antenna, and the signal is fed to or from the rest of the transmitter or receiver at a lower frequency, using coaxial cable. A waveguide is considered an unbalanced ...

6. Low-noise block downconverter - Wikipedia

   en.wikipedia.org/wiki/Low-noise_block_downconverter

   The microwave signal from the dish is picked up by a feedhorn on the LNB and is fed to a section of waveguide. One or more metal pins, or probes, protrude into the waveguide at right angles to the axis and act as antennas, feeding the signal to a printed circuit board inside the LNB's shielded box for processing. The lower frequency IF output ...

7. Power dividers and directional couplers - Wikipedia

   en.wikipedia.org/wiki/Power_dividers_and...

   At ports 2 and 3 the signal arrives in phase and adds whereas at port 4 it is out of phase and cancels. Ports 2 and 3 are in phase with each other, hence this is an example of a 0° hybrid. Figure 12 shows a planar implementation but this design can also be implemented in coax or waveguide.