Search results
Results from the WOW.Com Content Network
It is based on RS-232 serial communications at 9600 bit/s, 8N1, no flow control typically though a DE-9 connector, but can also be on 8-Pin DIN, RJ45 and RJ11 connectors used in daisy chain configurations. [1] VISCA utilizes a serial repeater network configuration to communicate between the PC (device #0) and up to 7 peripherals (#1 through #7).
Camera Link is a serial communication protocol standard [1] designed for camera interface applications based on the National Semiconductor interface Channel-link. It was designed for the purpose of standardizing scientific and industrial video products including cameras, cables and frame grabbers .
COM (communication port) [1] [2] is the original, yet still common, name of the serial port interface on PC-compatible computers. It can refer not only to physical ports, but also to emulated ports, such as ports created by Bluetooth or USB adapters.
In 1989, HP developed their TML language [10] which was the forerunner to SCPI. The IEC developed their own standards in parallel with the IEEE, with IEC 60625-2-1993 (IEC 625). In 2004, the IEEE and IEC combined their respective standards into a "dual logo" IEEE/IEC standard IEC 60488-2-2004 , Part 2: Codes, Formats, Protocols and Common ...
Software flow control is a method of flow control used in computer data links, especially RS-232 serial. It uses special codes, transmitted in-band, over the primary communications channel. These codes are generally called XOFF and XON (from "transmit off" and "transmit on", respectively). Thus, "software flow control" is sometimes called "XON ...
A male D-subminiature connector used for an RS-232 serial port on an IBM PC compatible computer along with the serial port symbol. A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1]
Many RS-232 driver chips have inbuilt charge pump circuitry to produce the required voltages from a 3 or 5 volt supply. RS-232 drivers and receivers must be able to withstand indefinite short circuits to the ground or to any voltage level up to ±25 volts. The slew rate, or how fast the signal changes between levels, is also controlled.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...