Ad
related to: 120 ohm termination resistor value table chart
Search results
Results from the WOW.Com Content Network
Two decades of E12 values, which would give resistor values of 1 Ω to 82 Ω The E series is a system of preferred numbers (also called preferred values) derived for use in electronic components . It consists of the E3 , E6 , E12 , E24 , E48 , E96 and E192 series, [ 1 ] where the number after the 'E' designates the quantity of logarithmic value ...
Graph of two decades of E12 series resistor values, which gives resistor values from 1 to 82 ohms (Ω) The E series is another system of preferred numbers. It consists of the E1, E3, E6, E12, E24, E48, E96 and E192 series.
For resistances following the (E48 or) E96 series of preferred values, the former EIA-96 as well as IEC 60062:2016 define a special three-character marking code for resistors to be used on small parts. The code consists of two digits denoting one of the "positions" in the series of E96 values followed by a letter indicating the multiplier.
Termination resistors also reduce electrical noise sensitivity due to the lower impedance. [further explanation needed] The value of each termination resistor should be equal to the cable characteristic impedance (typically, 120 ohms for twisted pairs). The termination also includes pull up and pull down resistors to establish bias for each ...
During writes, the output impedance of the DRAM device is approximately 45Ω. It is recommended that the SDRAM be implemented with a 240Ω. Assuming the RZQ resistor is 240Ω, Termination resistors can be configured to present an On-Die Termination (ODT) of RZQ/4 for an effective termination of 40Ω.
For many systems, the terminator is a resistor, with a value chosen to match the characteristic impedance of the transmission line and chosen to have acceptably low parasitic inductance and capacitance at the frequencies relevant to the system. Examples include 75-ohm resistors often used to terminate 75-ohm video transmission coaxial cables.
A terminator is a stand-alone male connector with an integral 120 Ω resistor connected across the primary data signal pair; this resistor matches the cable's characteristic impedance. If a secondary data pair is used, a termination resistor is connected across it as well.
(room temperature) (alpha, polycrystalline) calculated from single crystal values 56.2 LNG (10 −8 Ωm) 56.2 WEL (10 −8 Ωm) (293 K–298 K) 55 22 Ti titanium; use 0.39 μΩm 0.420 μΩm CRC (10 −8 Ωm) 39 LNG (10 −8 Ωm) 42.0 WEL (10 −8 Ωm) (293 K–298 K) 40 23 V vanadium; use 24.1 nΩm 181 nΩm 197 nΩm 201 nΩm 202 nΩm 348 nΩm
Ad
related to: 120 ohm termination resistor value table chart