enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.

3. Astragal - Wikipedia

   en.wikipedia.org/wiki/Astragal

   An astragal is commonly used to seal between a pair of doors. The astragal closes the clearance gap created by bevels on one or both mating doors, and helps deaden sound. The vertical member (molding) attaches to a stile on one of a pair of either sliding or swinging doors, against which the other door seals when closed.

4. Double margin doors - Wikipedia

   en.wikipedia.org/wiki/Double_margin_doors

   An example of a double margin door can be seen at the entrance to 10 Downing Street. A bench joiner will need to be aware of the correct procedure for assembly of this type of door. Firstly he will glue and wedge the rails to the meeting stiles and then join the two meeting stiles together with the folding wedges, the through top rail and the ...

5. Door - Wikipedia

   en.wikipedia.org/wiki/Door

   Rebated doors, a term chiefly used in Britain, are double doors with a lip or overlap (i.e. a rabbet) on the vertical edge(s) where they meet. Fire-rating can be achieved with an applied edge-guard or astragal molding on the meeting stile, in accordance with the American fire door.

6. Bullnose - Wikipedia

   en.wikipedia.org/wiki/Bullnose

   Bullnose trim is used to provide a smooth, rounded edge for countertops, staircase steps, building corners, verandas, or other construction.Masonry units such as bricks, concrete masonry units or structural glazed facing tiles may be ordered from manufacturers with square or bullnosed corners.

7. Fire door - Wikipedia

   en.wikipedia.org/wiki/Fire_door

   Door clearances at the door edge of the door frame (Wood Door), on the pull side of the door, do not exceed clearances listed in 4.8.4 (the clearance under the bottom of the door shall be a maximum of 3/4") and 6.3.1 (top & edges 1/8") Metal door (top & edges up to 3/16")