Search results
Results from the WOW.Com Content Network
Austenite, also known as gamma-phase iron (γ-Fe), is a metallic, non-magnetic allotrope of iron or a solid solution of iron with an alloying element. [1] In plain-carbon steel , austenite exists above the critical eutectoid temperature of 1000 K (727 °C); other alloys of steel have different eutectoid temperatures.
Its primary crystalline structure is austenite (face-centered cubic). Such steels are not hardenable by heat treatment and are essentially non-magnetic. [2] This structure is achieved by adding enough austenite-stabilizing elements such as nickel, manganese and nitrogen.
Microstructures of four kinds of duplex stainless steel in each direction. Duplex stainless steels are usually divided into three groups based on their pitting corrosion resistance, characterised by the pitting resistance equivalence number, PREN = %Cr + 3.3 %Mo + 16 %N.
The specific cooling rate that is necessary to avoid the formation of pearlite is a product of the chemistry of the austenite phase and thus the alloy being processed. The actual cooling rate is a product of both the quench severity, which is influenced by quench media, agitation, load (quenchant ratio, etc.), and the thickness and geometry of ...
From Wikipedia, the free encyclopedia. ... Austenite; From an adjective: This is a redirect from an adjective, which is a word or phrase that describes a noun, ...
For a eutectoid steel (0.76% C), between 6 and 10% of austenite, called retained austenite, will remain. The percentage of retained austenite increases from insignificant for less than 0.6% C steel, to 13% retained austenite at 0.95% C and 30–47% retained austenite for a 1.4% carbon steel. A very rapid quench is essential to create martensite.
Austinite is a member of the adelite-descloizite group, adelite subgroup, the zinc (Zn) end member of the copper-Zn series with conichalcite.It is the zinc analogue of cobaltaustinite and nickelaustinite. [4]
Some of the austenite phase mentioned above is mechanically metastable and will form martensite when subjected to high stress. The combination of hard, wear-resistant martensite with ausferrite results in good wear properties, as the regions near a crack tip strengthen and prevent further propagation.