Search results
Results from the WOW.Com Content Network
These cables still only supported two drives, one before and one after the twist, but they allowed using one cable for any combination of drives with differing connectors. This type of cable is called a universal cable. [8] When multiple floppy disks are connected, many pins are shared, including the read and write data pins.
Many types of Berg connectors exist. Some of the more familiar ones used in IBM PC compatibles are: the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in ...
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
A floppy-disk controller (FDC) is a hardware component that directs and controls reading from and writing to a computer's floppy disk drive (FDD). It has evolved from a discrete set of components on one or more circuit boards to a special-purpose integrated circuit (IC or "chip") or a component thereof.
The ST-506 and ST-412 (sometimes written ST506 and ST412 [1]) were early hard disk drive products introduced by Seagate in 1980 and 1981 respectively, [1] that later became construed as hard disk drive interfaces: the ST-506 disk interface and the ST-412 disk interface. Introduced in 1980, the ST-506 was the first 5.25 inch HDD.
The desktop computer hard-drive connector (AMP Mate-n-Lok 1-480424-0 power connector) is standard on all 5.25-inch floppy drives, 3.5-inch PATA and non-SCA SCSI disk drives; however, newer SATA disk drives employ a more advanced interconnection with 15 contacts. These advanced connection systems were first developed by Molex and other connector ...
A disk controller is a controller circuit that enables a CPU to communicate with a hard disk, floppy disk or other kind of disk drive. It also provides an interface between the disk drive and the bus connecting it to the rest of the system. [1] [2] Early disk controllers were identified by their storage methods and data encoding.
IEC 60320, connectors for power supply cords to electrical appliances; Molex connector, four-pin hard disk drive (HDD) connectors, also used for powering CD-ROM drives, burners etc. Berg connector, smaller four pin floppy disk drive (FDD) connectors, also used by some hard drives, and carrying the same power supplies as the HDD connectors