Search results
Results from the WOW.Com Content Network
Typical POST screen (AMI BIOS) Typical UEFI-compliant BIOS POST screen (Phoenix Technologies BIOS) Summary screen after POST and before booting an operating system (AMI BIOS) A power-on self-test ( POST ) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on.
The actual key depends on specific hardware. The settings key is most often Delete (Acer, ASRock, Asus PC, ECS, Gigabyte, MSI, Zotac) and F2 (Asus motherboard, Dell, Lenovo laptop, Origin PC, Samsung, Toshiba), but it can also be F1 (Lenovo desktop) and F10 . [50] Features present in the BIOS setup utility typically include:
UEFI replaces the BIOS that was present in the boot ROM of all personal computers that are IBM PC compatible, [5] [6] although it can provide backwards compatibility with the BIOS using CSM booting. Unlike its predecessor, BIOS, which is a de facto standard originally created by IBM as proprietary software, UEFI is an open standard maintained ...
Legacy BIOS bootable (equivalent to active flag (typically bit 7 set) at offset +0h in partition entries of the MBR partition table) [13] 3–47: Reserved for future use 48–63: Defined and used by the individual partition type
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module.Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
Overclocking BIOS setup on an ABIT NF7-S motherboard with an AMD Athlon XP processor. Front side bus (FSB) frequency (external clock) has been increased from 133 MHz to 148 MHz, and the CPU clock multiplier factor has been changed from 13.5 to 16.5. This corresponds to an overclocking of the FSB by 11.3 percent and of the CPU by 36 percent.
[f] Many motherboards enabled overclocking of these from the default 6 or 8 MHz to perhaps 16.7 or 20 MHz (half the i486 bus clock) in several steps, often from within the BIOS setup. Especially older peripheral cards normally worked well at such speeds as they often used standard MSI chips instead of slower (at the time) custom VLSI designs ...